Broyce Control has not written a bio yet…
Demonstration of the relay operation when simulating an undervoltage and overvoltage condition.
The LMCVR-500V is designed to monitor for under or overvoltage conditions. Here we demonstrate the operation of the relay when set for undervoltage monitoring.
The LEYD/A is used to limit the duration a 3-phase motor runs in Star configuration before switching over to Delta.
Designed for monitoring the voltage of 12V or 24V batteries and sense when the voltage drops below a pre-set trip point. It can be used to trigger or initiate the re-charging of the battery if the voltage gets too low.
Demonstration of the LART operation. Asymmetrical functionality allows for both the "on" and "off" periods to be set independently. Being supply initiated, it is possible to configure the timer to either start with the relay energised or de-energised
The LR44/3 Logic Relay (also known as Load Sharing and Alternating Relay) is used typically for balancing wear between pumps and compressors in many types of applications.
Phase loss/phase reversal faults can cause damage to equipment/machinery and also pose risks to personnel if allowed to persist. The LXPRC/S is designed to detect such conditions. Here we demonstrate product operation when simulating these faults.
6 months ago
Watch the video to help install and setup the LMMT Multi-function timer relay.
This video shows the setting up procedure for the Earth Leakage relay which can be carried out in just a few simple steps. As the relay is NFC based, setting up can still be done without power applied.
Learn how to change the timing function and set the time delay period.
This short video shows the setting up procedure for the LPRC/2-NFC 3-Phase voltage relay which can be carried out in just a few simple steps...