New to DSM and have a question. I am trying to put in 'points' in the 2d skech plan view drawing before going 3d. However there are no popups to input the coordinates. I am trying to put the points in precomputed coordinates but in .0625" (1/16") varying increments. Sometimes I have to go to 0.03125" (32nds). Trying to use the x and y in the bottom bar does not work since it is too sensitive to super small moves of the mouse.
I guess I could just put in the point close and then use the move tool but I tried it and doing that is horribly cumbersome as I need to put in 75 points accurately!
Any ideas?
Thanks in advance
FB
EX: X = 22.8125; Y = 0.9375
Comments