Skip to main content
shopping_basket Basket 0

Can the RS Pro 450 Mw light controller sensor (stock no 791 8260) be switched between sensing mode and permanently on?g

0 Votes


September 22, 2019 10:31

You may be able to wire a switch like such that 1 gang provides on/off and the other gang provides sensor/permanently on as in the attached diagram. I had this arrangement with a previously installed, but older PIR (relay out) + Lamp arrangement.
There are not enough circuit details to confirm this will work, but I cannot think of any reason bypassing the electronic control (now often a triac) with a switch will do any harm, but you may need to investigate further.
There is nothing in the supplied data to show a built-in option for this.

0 Votes
DesignSpark Electrical Logolinkedin