Skip to main content
shopping_basket Basket 0
Login

808-6636 Digital counter

Hi everyone , First time posting here.

I have this digital counter that i have set to count to 10 when sensors are activated it activates the output and when other sensor activates and counts back down to 9 the output turns off .. all works fine.

I would like to programme the unit so it will not count over 10 even when a semsor is activated on the upcount or go below 0 if the downcount sensor is activated. so in effect only work between the numbers of 0-10 , would anyone know the programming for this?

Thank you 

Comments

September 1, 2020 09:30

Hi Adam, welcome and thanks for your first post :) I can see we haven't had any community responses to your question, so I have contacted my colleagues in the RS Pro team to see if we can get some advice for you on this.

0 Votes
DesignSpark Electrical Logolinkedin