Skip to main content

Pouring copper on bottom of 2 layer board.


testengr

I was able to pour copper to the top side of my 2 layer pcb without problems. When I tried to do the same for the bottom of the pcb, I got an error that said that "you can't do that here, do you want to enable the correct layer". I don't remember the exact words. If I choose to enable the correct layer, it takes me back to the top layer showing the pour that was done before.

have spent quite a while looking at the help files with no results. Your pcb software is running on a Windows 10 latop. If you could provide me with step by step instructions or point me to a place in the help files that describes what I am trying to do. 

Thanks

testengr

DesignSpark Electrical Logolinkedin