I have basically finished my pcb, ran the Design Rule Check Report and it looked good.
I then ran the Gerber Output via Manufacturing Plots. I then used GerberView to confirm results. Everything looks good.
However, in Plot Report.txt I get D-Code Shape (thou) reports that are concerning. Such as D11 Round 5.00 (thou).
I have searched Help and the Forums but nothing about D-Codes or D11. How do I find the exact location for these D-Codes?
The following are in Top Documentation.gbr, Top Silkscreen.gbr, Bottom Copper.gbr, etc.
Layers:
---------------------
Top Documentation
D-Code Shape (thou)
-----------------------
D11 Round 5.00
Layers:
------------------
Top Silkscreen
D-Code Shape (thou)
-----------------------
D10 Round 1.00
D11 Round 5.00
D77 Round 8.00
Layers:
------------------
Top Copper
Board Outlines
D-Code Shape (thou)
------------------------------------------
D11 Round 5.00
Layers:
------------------
[Through Hole]
D-Code Shape (thou)
-----------------------
D11 Round 5.00
D16 Round 100.00
ayers:
------------------
Board Outlines
D-Code Shape (thou)
-----------------------
D11 Round 5.00