Skip to main content

Hurdle Detecting Robot Using Raspberry Pi

This short article introduces my Raspberry Pi-Based Obstacle Avoiding Robot using an ultrasonic sensor and programming in Python.

Components

  • Diode 
  • Resistor 
  • L298N H bridge motor controller
  • DC motors
  • Raspberry Pi 3
  • Sonar sensor 
  • Battery
  • Capacitor
  • LEDs 

Project Hardware

In terms of the circuit configuration required in the project, I'm assuming that you have the equipment required and have already installed the required libraries. A block diagram of the overall project is shown below:

Hurdle-detecting-robot_1092c210ebc37042d44fc6eaa927270f92937933.jpg

Check out the project code and full instructions here...

you can also check may be helpful for u

raspberry pi gpio python

python web server

I am engineer from MicroSolution We deal in microcontroller programming and hardware
DesignSpark Electrical Logolinkedin