Designspark Workshop in Rangsit University by Republic Polytechnic

On 20 March 2015, an introduction workshop for DesignSpark Mechanical and DesignSpark PCB was conducted in Rangsit University Bangkok, Thailand. Three students from Electronic Product Development Lab, SEG, and Republic Polytechnic conducted this workshop, which was sponsored by RS Components.

Through this workshop, DesignSpark Mechanical and DesignSpark PCB was introduced to student and lecturers from Rangsit University. The presentation for this workshop not only covered the introduction of RS components and both soft wares but also included the demonstrations of those two soft wares. Through the demonstrations, the students could gain a better understanding of the main features of the software.

 A Q&A session was set at the end of the presentation to solve the doubts from the audience. Many questions were raised by the students and lecturers from Rangsit University. This indicated their interest in the soft wares.

This collaboration event between RS Components and Republic Poly was a success. It helped in building a good relationship between Republic Polytechnic and Rangsit University. At the same time, it helped lecturers from Rangsit University to understand more about RS Components as well as its products.

Below are some photos taken during the workshop:

 Staff rrom Rangsit University

 Students from Rangsit University

Introduction of DesignSpark Workshop

Students from RP Electronic Product Development Lab conducting the Workshop